First, cutting plate saw operation intention

Through the standard operation procedure, make the cutting board saw processing parts meet the quality requirements, prevent the accident caused by non-standard operation.

Two, cutting board saw applicable scope

Three, cutting board saw operation preparation

1. Clean the machine and working place;

2. Check whether the vacuuming system is normal;

3. Check whether the pushing table saw blade is sharp and whether the large and fine saw blade is in a line. Test the machine for 1 minute to see if the machine runs normally;

4. Prepare materials and accessories.

Four, cutting board saw operating procedures

1. Check the power switch before starting the machine;

2. Use the waste test machine (cut 100mm);

3. Read the order carefully, calculate the number of plates required to be cut according to the cutting instructions, and wait for the next operation;

4. Put the plate on the pushing bed and adjust the scale of the gear position;

5. Adjust the opening speed according to the hardness and thickness of the plate, and push the pushing bed at an even speed;

6. When the plate is opened about 50mm, the receiver begins to pick it up by hand, so that the plate persists in translation until the opening is completed;

7. In the cutting process, we should adhere to the line cutting large pieces, and cut small pieces with scraps to ensure the optimization rate of cutting;

8. For each specification of the plate, it is necessary to make the first self-check to see whether the length, width and diagonal scale meet the quality requirements, and whether the adjacent two sides adhere to 90°. (Simple discrimination method: compare the synchronized parts with the next parts in turn);

9. The cut plate should be placed flat on the turnover car according to the requirements, and the soft plate should be separated between the plates. According to the requirements of the same type of products placed, pay attention to the maintenance of corners;

10. In the process of plate transportation, the motor is closed to save electricity and improve the service life of the motor;

11. After the operation is finished, cut off the power supply, dust out for the machine, clean the remaining materials, etc.

Five, cutting board saw note matters

1. When working, it is forbidden to wear loose clothes, sleeves rolled above the elbow or the new QQ tight, long hair must be rolled up, no gloves;

2. Before starting the machine, check whether the power switch, large and small saw blades are replaced. After changing the saw blades, the nuts must be tightened. Test saw with scrap before formal cutting to check whether large and small saw blades are parallel;

3. Budget data by yourself after receiving production instruction, and report immediately if there is any abnormality;

4. Wear a good eye shield when cutting, and insist on a certain interval between the hand and the saw. In the process of blanking, do not use your hands to take the residual material between the saw and the backer, and use the small plate to push away;

5. All kinds of plates should be cut to improve the utilization rate of plates. Plates over 40mm cannot be discarded;

6. After replacing the new saw blade, the data should be adjusted in time to avoid processing errors (thickness of saw blade and positive and negative direction of installation);

7. The finished products should be placed according to the class. Different types of plates should be marked clearly, and the next process should not be affected by random cutting;

8. When replacing the saw blade, pay attention to the direction and thickness of the saw blade. During the replacement process, it is necessary to turn off the machine and pay attention to safety;

9. The finished product shall be sent to the person in charge of the next process and signed for confirmation according to the different procedures;

10. Open small material (less than 100mm), the data can not be pushed by hand, the use of wood to press the push;

11. Shut off the power supply of the machine after work, and clean the machine and working area;

12. The title information of the cut and finished parts must be filled in truthfully, and the information of the production process card must be filled in carefully;

13. The castoffs should be placed separately according to the thickness, color and size, so as to be used next time.