1. The plate will be classified according to the size of the specification, it is necessary to select the panel, side plate and so on before punching, the plate must be handled lightly;

2. To the width of the largest number of plate size customization;

3. Use the flat drill and the vertical drill to finish all the large flat buckle. After finishing the hole of the same machine, if the machine needs to be adjusted, operate as above after adjusting the hole position;

4. The width of the drawer on both sides of the plate as the size of the benchmark, about customization; Two side plate thick leather together and placed in the center of the hole, the drawer panel on the left and right are increased 10mm and then placed on the platform drilling;

5. After finishing the hole, put all the plates on the trolley, do not leave them behind, and then classify and stack them together according to the plate standard;

6. Turn off the power supply of drill row and blow off the saw foam on the machine;

7. Every time to mobilize the machine or replace the drill or switch the drill position button, to self-check the machine, when the machine abnormal situation, should immediately press the emergency stop button, timely shutdown.